Toshiba DK14 Telephone User Manual


 
System & Station
Program 60-8 Call Forward External (Remote Change, Security) ID Code
Strata DK Programming 5/00 3-147
System & Station
Program 60-8 Call Forward External (Remote
Change, Security) ID Code
Processor Type: DK14, DK40i, all RCTUs and BCUs
Program Type: System
Initialized Default: No digits
Program 60-8 Overview
Changes a telephones External Call Forward destination to [PDNs] but not [PhDNs] from outside
the system. The person that wishes to change the destination must call into a DISA CO line, enter
the telephones [PDN] +
 and then enter a security code plus the destination telephone
number. CF/EXT ID code must be assigned to a telephone to allow callers to change the Call
Forward-External destination of that telephone from a remote location by calling in on a DISA CO
line.
The security code (1~15 digits) for each telephone is set with this program.
Important!
To allow Call Forward External, CO lines must be enabled for the following:
Two CO line connection in Program 10-1 and Program 15-5.
Outgoing Access in Program 41 including DISA port numbers.
   6SNU +ROG 6SNU  +ROG 6SNU +ROG 6SNU +ROG
Processor Type Port Range Processor Type Port Range
DK14 000~009 B1CU 000~055
DK40i 000~027 B2CAU/BU 000~111
RCTUA 000~031 B3CAU/BU 000~191
RCTUBA/BB 000~079 B5CAU/BU 000~335
RCTUC/D 000~239
RCTUE/F 000~335
Telephone Port
Number
CF/EKT ID Code
(1~15 digits)
Telephone Port
Number
CF/EKT ID Code
(1~15 digits)
Telephone Port
Number
CF/EKT ID Code
(1~15 digits)
More Codes
DATA = ID code (1~15 digits)
When entering less than 15 digits, enter digits,
then press Hold.
LED Button 01 = blanks, erases data
LED Button 02 = a wild card (can be any digit
from 1~9)
SELECT = 8
Telephone port number to
which the CF Ext ID (security)
code will be assigned.