Filter
Top Products
IP Phone 100 User Manual Guide Document Ver. 1.8
IP Phone Ver. 113/503(Normal and PPPoE)
30
18.[rom] command
1. -print: show versions of all rom files.
2. -app,-boot, -dsptest, -dspcore, -dspapp, -rbpcm and -htpcm: upgrade main boot code,
main application code, DSP testing code, DSP kernel code, DSP application code, Ring
Back Tone PCM file and Hold Tone .
3. -boot2m:to upgrade 2mb rom file, which includes all firmware file mentioned in item 2.
Note:
1. After 2mb file download is finished, all configurations might change to default value,
user has to configure again.
2. MAC address might change to default value also, please MUST use command setmac:
Usage: key in command setmac
key in MAC address (which you can see on a label attached at the bottom of
IP Phone )with format:
00
01
a8
00
0x
xx
(It means to press enter each time after key in two characters.)
4. -s: it is necessary to prepare TFTP/FTP server IP address for upgrading firmware rom file.
5. -f: the file name prepared for upgrading is necessary as well.
6. –server: specify TFTP/FTP server IP address. It is corresponding to LCD configuration
-firmware upgrade-Set file Server IP.
7. –method: specify download method to be TFTP or FTP(0 for TFTP.1 for FTP)
8. –ftp: specify user name and password for FTP download method
For example: User prepares to upgrade the latest app rom file – wtlp.103c, the TFTP server is
192.168.4.101.
rom –app –s 192.168.1.1 –f lp.100(If –server is specified , can just type rom –app –f lp.100)