Filter
Top Products
IP Phone 100 User Manual Guide Document Ver. 1.8
IP Phone Ver. 113/503(Normal and PPPoE)
10
Chapter 2 Operating Procedure – LCD Display Configuration
1.Initialize IP Phone 100
1. When power on the IP Phone 100, the LCD screen shows as below.
2. Wait around one minute until the IP Phone 100 finishes boot program initialization.
3. User can see flashing greeting as below:
4. Then IP Phone get into standby mode:
The main LCD screen would be shown as similar as above. The GK word means the IP
Phone 100 is in GateKeeper Mode, and when IP Phone is connected to SNTP server, on
LCD will show current time from SNTP server.
5. After pressing the PSTN button, the GK word will be replaced by PSTN. Then IP Phone is
in PSTN Mode. Please notice that in PSTN mode user must plug PSTN line in RJ-11 port.
Press or to enter configuration mode then press OK Bottom to enter certain menu.
There are 6 selections for configuration.
1. System Configuration (mandatory, protected by password)
2. User Line Number (mandatory)
3. Ring Configuration
4. Indicate Forward Type
5. Message Box
6. Phone Address Book
Note: LCD Panel of IP Phone 100 is operated manually by moving or on the keypad. Press
OK to enter separate configuration menu. Press C to go back to the main menu.
IP-Phone
Board Start Booting
System Initializing…………..
IP-Phone
GK 10:10:10 AM
IP-Phone
PSTN 10:10:10 AM