Filter
Top Products
IP Phone 100 User Manual Guide Document Ver. 1.8
IP Phone Ver. 113/503(Normal and PPPoE)
17
Chapter 3 Advanced Configurations via Telnet
After initializing the IP Phone 100 IP Address setting (please refer to LCD Configuration:
1.Connect Configuration), user can enter into configuration mode via telnet. There are 18
commands listed below.
Note:
1.After user enter IP Phone configuration via telnet, please use login : ”root”,
password : ”press enter” to enter command line.
2.Each command user must key-in with lower case, but contents of configurations such as
h.323 alias or user name etc, user can set as capital case.
3.User who changes any configuration needs to do the commit command then reboot
command.
1. [help] command
Type help or man or ? to display all the command lists. The following figure is shown all
commands of IP Phone 100.