Filter
Top Products
IP Phone 100 User Manual Guide Document Ver. 1.8
IP Phone Ver. 113/503(Normal and PPPoE)
23
11.[sysconf] command
This command displays the system information and configuration.
1. -print: display system overall information and configuration.
2. -plan: It is for setting dial numbering plan. While e164 number is three digits, the plan
should be set as 3 or 0. The plan 0 is for any positive digits use.
3. –callalive: Enable or disable auto-disconnection after 10 seconds not receiving packets from
remote party(sysconf –callalive 0/1, 0 for disable and 1 for enable)
4.-keypad:set DTMF type .User can select DTMF type IP Phone receive and
transmit.(sysconf –keypad 0/1/2/3 , 0 for inband ,1 for H.245 alphanumeric, 2 for H.245
signal type, 3 for Q.931 user info, 4 for RFC2833.)
5.-idto:set the duration(in second) of two pressed digits in dial mode as timed out. If after the
duration user hasn’t pressed next number, IP Phone will dial out all number pressed.
6.-eod:select end of dialing key, e.g set end of dial key as OK button , after finished pressing
dialing number then press OK will dial out. (sysconf –eod 0/1/2/3 , 0 for no end of dial key ,
1 for “OK” button , 2 for “#” button , 3 for “ ” button )
7.-h450:Enable or disable H.450 related features, which include transfer, hold and forward.