Filter
Top Products
IP Phone 100 User Manual Guide Document Ver. 1.8
IP Phone Ver. 113/503(Normal and PPPoE)
22
10.[pppoe] command
Note: Firmware of IP Phone are separate into normal version and PPPoE version.
1. This command can only see in PPPoE version, in normal version PPPoE function is not
implemented.
2. In PPPoE version has no TOS command.
1. -print: display system overall information and configuration. IF IP Phone has already
connected to PPPoE server, user can see IP address and related information with this
command.
2. -dev: to enable or disable PPPoE function.(pppoe –dev 0/1)
3. –open: to open PPPoE connection(If IP Phone is not in PPPoE connection, user can try to
connect with pppoe -open)
4. –close: to close PPPoE connection(If IP Phone is in PPPoE connection, user can disconnect
with pppoe -close)
5. –id: to set PPPoE connection user name
6. –pwd: to set PPPoE connection password
7. –reboot: If user enable this function, after PPPoE being disconnected, IP Phone will
automatically reboot to re-connect, and after reboot, if IP Phone still can’t get contact with
server, IP Phone will keep trying to connect. On the other hand, if user disable this function,
IP Phone won’t reboot and keep trying to connect.(pppoe –reboot 0/1)