Filter
Top Products
IP Phone 100 User Manual Guide Document Ver. 1.8
IP Phone Ver. 113/503(Normal and PPPoE)
29
16. [support] command
1.-print : display current SUPPORT values configurations.
2.-fstart: enable or disable fast start (support –fstart 0/1 , 0 for disable and 1 for enable.)
3.-tunnel: enable or disable H.245 tunnel function.(support –tunnel 0/1 , 0 for disable and 1
for enable)
4.-h245fs:set if open H.245 separate channel after fast start or not. (support –h245fs 0/1 , 0
for open and 1 for not.)
17. [bureau] command
Type bureau can display commands below.
1. -print: display bureau line information and configuration.
2. -hold: set hold tone generation on or off. If other terminals support H.450 hold function, and
execute hold function when connecting with IP Phone 100, user will hear hold tone from IP
Phone 100. (0 for off ,1 for on)
Note: When fast start function is enabled, if user wants to send DTMF message after
connection, IP Phone will send out Q.931 message. (Please refer to 11.sysconf –keypad
command, which can only set keypad as q.931 message at this time)