Filter
Top Products
IP Phone 100 User Manual Guide Document Ver. 1.8
IP Phone Ver. 113/503(Normal and PPPoE)
11
2.LCD Configuration
User can set the following 10 configurations manually by operating the commands displayed on
LCD.
Note: Any configurations that have made for the IP Phone 100, user has to do Reboot in the
selection 1 5 “Reboot”.
1. System Configuration (mandatory, protected by password)
Please Enter Password:
User must key in password to enter this menu, selections under this command are all
important ones, which can only be configured by administrators.
Note: Password to enter System Configuration:
H.323 token password (please refer to item 9), default value is x
1. Connect Configuration
There are ten sub-configurations included in Connect Configuration. It is necessary
for user to set it in order to run the IP Phone 100 correctly.
In addition, user has to prepare one valid IP Address to meet your network
environment. (Global public IP Address or Virtual IP Address)
(1) IP address
In this configuration mode, user presses the prepared IP Address on the IP Phone
keypad. Please input IP address as format: xxx.xxx.xxx.xxx.
(2) Subnet Mask:
User has to press the subnet mask IP Address on the IP Phone keypad.
(3) Gateway
User has to press the default gateway IP which meets IP Address on the IP Phone
keypad.
(4) Primary DNS
User can set IP address of Domain Name Server, then for GateKeeper and Phone
book can enter URL address or IP address. Please refer to 3.9 [pbook] and 3.12
[h323] command.
(5) Secondary DNS
User can set IP address of secondary DNS, once primary DNS cannot work
normally, IP Phone can refer to secondary DNS.
(6) GateKeeper
User has to offer one available GateKeeper server IP Address and set this IP
Address on the IP Phone keypad.
(7) Second GateKeeper