Filter
Top Products
IP Phone 100 User Manual Guide Document Ver. 1.8
IP Phone Ver. 113/503(Normal and PPPoE)
21
9. [pbook] command
The command is for Peer-to-Peer Mode use only. Therefore, our VoIP products such as IP
Phone 100 that support Peer-to-Peer Mode are also available to be addressed on the IP Phone
100 phone book.
1.-print: display phone book data. User can print all data in phone book by command
(pbook –print). Furthermore, user can also print only a section of data by indicate
parameter 'start_record' and 'end_record' (pbook –print “start prefix” “end prefix”). If
parameter 'end_record' is omitted, only record 'start_record' will be display (pbook –print
“start prefix”).
2.-add: add a new record in phone book table by give a name and e164 number for the
Gateway / Terminal IP address .
(pbook –add name “X” ip “xxx.xxx.xxx.xxx” e164 “X”)
User can set IP or URL address( Domain Name Server must be configured. Please refer to 6.
[ifaddr] command)
3. -search: search any record such as ip address, name and e164 addressed on the phone book.
4. -delete: delete a record with index listed in phone book table. (pbook –delete “index
number”)
5. -insert: insert an record in specified index of phone book.
6. -modify: modify any record that has addressed to index number. The name, IP address and
e164 number should be modified together in one modify command.
(pbook –modify “index” name “X” ip “xxx.xxx.xxx.xxx” e164 “X”)
Note: Please dial “#” after dial e.164 of pbook .