Filter
Top Products
Getting Started 9
Getting Started
• 500 numbers stored in your Contacts list. Each Contact can have up to 5
phone numbers each. See "Contacts" on page 105.
• Hands-free interface using Voice Service.
• Menus and options that you can view in English or French.
Turning Your Phone On and Off
To turn your phone on:
• Press and hold to turn your phone on.
Once your phone is On, it displays “Looking for Service” which indicates that your
phone is searching for a signal. When your phone finds a signal, it automatically
enters standby mode – the phone’s idle state. At this point, you are ready to begin
making and receiving calls.
If your phone is unable to find a signal after 15 minutes of searching, a Power Save
feature is automatically activated. When a signal is found, your phone automatically
returns to standby mode.
In Power Save mode, your phone searches for a signal periodically without your
intervention. You can also initiate a search for service by pressing any key (when
your phone is turned On).
Tip: The Power Save feature helps to conserve your battery power when you are in
an area where there is no signal.
To turn your phone off:
• Press and hold for two seconds until you see the powering down
animation on the display screen.
Your screen remains blank while your phone is off (unless the battery is charging).
Using Your Phone’s Battery and Charger
Battery Capacity
Your phone is equipped with a Lithium Ion (LiIon) battery. It allows you to recharge
your battery before it is fully drained.
When the battery runs low, the battery icon will blink to remind you to recharge the
battery. When the battery capacity is close to completely drained, the phone
sounds an audible alert and then powers down.
END
END