Filter
Top Products
5.3 TELEPHONE COMPANY INTERFACES
CIRCUIT TYPE FIC NETWORK JACK
RJ21X
C.O. LINE—LOOP START O2LS2 RJ11C
RJ14C
E & M TIE LINE TL11M RJ2GX
RJ21X
OFF PREMISES EXTENSION OL13C RJ11C
RJ14C
NOTE: Allowing this equipment to be operated in such a manner as to not provide for
proper answer supervision is a violation of part 68 of the FCC’s rules.
RINGER EQUIVALENCE (REN)
The REN is used to determine the quantity of devices which may be connected to the
telephone line. Excessive RENs on the telephone line may result in the devices not ring-
ing in response to an incoming call. In most but not all areas, the sum of the RENs should
not exceed 5.0. To be certain of the number of devices that may be connected to the line,
as determined by the number of RENs, contact the telephone company to determine the
maximum REN for the calling area.
INCIDENCE OF HARM
If the terminal equipment, the iDCS 100, causes harm to the telephone network, the tele-
phone company will notify you in advance that temporary discontinuance of service may
be required. But if advance notice is not practical, the telephone company will notify the
customer as soon as possible. Also, you will be advised of your right to file a complaint
with the FCC if you believe it is necessary.
CHANGES TO TELEPHONE COMPANY EQUIPMENT OR FACILITIES
The telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the operation of the equipment. If this happens, the tele-
phone company will provide advance notice in order for you to make the necessary modi-
fications so that you may maintain uninterrupted service.
SERVICE CENTER
If trouble is experienced with the iDCS 100, please contact your local SAMSUNG TELE-
COMMUNICATIONS AMERICA at (305) 592-2900 for repair or warranty information. If the
trouble is causing harm to the telephone network, the telephone company may request
that you remove the equipment from the network until the problem is resolved.
5.2
HOME
PAGE
Table of
Contents