Filter
Top Products
2.3 MEM3 AND MEM4 CARD
To operate, the KSU must be equipped with an iDCS 100 MEM3 card or an iDCS 100
MEM4 card to hold the system software and customer database. The MEM3 card sup-
ports our standard version of software and it is stored in EPROM chips. The Enhanced
version of software can only be found on the MEM4 card and this software is stored in
non-removable flash memory. All specific customer data is stored in non-volatile randon
access memory (NV-RAM) for both MEM cards. The MEM3 and MEM4 cards protect all
specific customer data with a super capacitor providing up to seven days of memory
protection in the event of loss of AC power to the system.
2.4 INTERFACE CARDS
2 SLI
This card is installed in a dedicated slot on the KSU motherboard. The card provides two
single line telephone interfaces equipped with OPX protection and the ability to provide
a loop disconnect signal. This is the same card used on the DCS Compact and 50si.
2 x 4 DLI
This card provides two Caller ID-compatible loop start C.O. interfaces and four 1B+D DLI
ports. KDb’s cannot be used with this card. This is the same card used on the DCS Com-
pact and 50si.
S8DLI
This card provides eight 1B+D DLI ports. KDb’s cannot be used with this card.
2 x 4 SLI
This card provides two Caller ID-compatible loop start C.O. interfaces, four SLI ports for
industry standard single line telephones and the ability to provide a loop disconnect
signal.
NOTE: This card does not provide OPX protection. This is the same card used on the
DCS Compact and 50si.
S8SLI
This card provides eight SLI ports for industry standard single line telephones and the
ability to provide a loop disconnect signal.
NOTE: This card does not provide OPX protection.
S3TRK
This card provides three Caller ID-compatible loop start C.O. interfaces with power failure
transfer on the first two ports.
2.2
HOME
PAGE
Table of
Contents