Filter
Top Products
BUSY STATION CALLBACK
When reaching a busy station, callers may request a callback by pressing one
button or dialing a code. The system rings the caller back when that station be-
comes idle (a system-wide maximum of 100 callbacks are allowed at one time
including busy station and busy trunk).
BUSY STATION INDICATIONS (BLF)
DSS/BLF keys may be assigned to any keyset or add-on module. These buttons
will be off when the station is idle, light red when that station is in use and flash
distinctively when that station is in the DND mode. The system can be programmed
to allow the DSS keys to be used to pickup calls at other keysets.
CALL FORWARDING
Station users can forward internal and outside calls to other destinations immedi-
ately (Forward All), when busy (Forward Busy) or if not answered in a program-
mable number of seconds (Forward No Answer). These forward destinations can
all be different. Once a destination has been programmed, it can be turned on and
off with a programmable key. Forward All takes priority over Busy and No Answer
conditions.
In addition to the three usual methods of forwarding described above, a fourth
option called Follow Me is available. This option allows a station user to set a For-
ward All condition from his/her station to another station while at the remote station.
To display the Follow Me condition, the TRSF key lights steady red at the station
that is forwarded. The TRSF key also lights if Forward All is set and no key is pro-
grammed for Forward All.
Keyset users can be given an external call forward button to forward their calls to
an external phone number. Each outside line may be programmed to either follow
or ignore station call forwarding. A per-station option controls whether internal calls
forward to voice mail or not. Single line telephones must have the system adminis-
trator program this feature for them.
CALL FORWARD OVERRIDE
When this option is set to yes for a station then intercom calls from that station will
override any call forwarding settings of the called station.
CALL LOGS (Enhanced Version Software/MEM4 Only)
With the call log feature, a display keyset user can review up to 50 of the last incom-
ing calls from the Caller ID review list or up to 50 of the last external telephone
numbers that were dialed. The numbers can be viewed, stored and/or dialed us-
ing the associated soft keys. LCR must be enabled for dialing and storing num-
bers from the CID review list. Optional hardware and/or software may be needed
for Caller ID.
4.33
HOME
PAGE
Table of
Contents