Filter
Top Products
Deregistering a Handset
Mitel
®
5000 CP IP DECT Stand Configuration and Administration Guide – Issue 1.0, May 2010 Page 41
Deregistering a Handset
Use the following procedure to deregister a handset.
To deregister a handset from an IP DECT Stand:
1. From Idle mode, press the OK key, select Settings, and then press the OK key.
2. Select System settings and press the OK key. When prompted for a PIN code, enter
the PIN code (default 0000), and then press the OK key.
3. Select Handset settings and press OK.
4. Select Deregister handset and press OK.
5. Deregister Handset? is displayed. Press Yes. After the handset is deregistered, the two
semi circles in the top left corner of the display both turn black.
6. Press Back repeatedly to return to the main display. The auto-registration message will
appear in the handset display.
Resetting the Stand to Default Settings
You can reset the stand to the default settings. This procedure clears all settings from the stand
and resets them to the defaults. The Configurator web interface user name and password are
reset back to the following:
User name: admin
Password: admin
Resetting the stand also clears the stand’s IP address. If the stand was configured with a static
IP address you will have to reprogram it. You will then have to reconfigure the handsets with the
stand. Note that you cannot register a handset while a call is being supported on another
handset because you will be unable to reset the stand.
To reset the stand:
1. Press and hold the RESET button on the rear panel of the stand for greater than 10
seconds. All four LEDs turn on solid.
2. Release the RESET button.
NOTE
To register the handset with the IP DECT Stand again, place the handset in the
cradle and reset the stand (gateway) by pressing the RESET button on the back
of the stand for 2 to 3 seconds.