Filter
Top Products
PIN Protection of Handset Menus
Mitel
®
5000 CP IP DECT Stand Configuration and Administration Guide – Issue 1.0, May 2010 Page 25
Configuration file example:
%SIP_STUN_ENABLE%:0
%SIP_RPORT_ENABLE%:1
%NETWORK_STUN_SERVER%:"stun01.sipphone.com"
%SIP_STUN_BINDTIME_GUARD%:80
%SIP_STUN_BINDTIME_DETERMINE%:0
%SIP_STUN_KEEP_ALIVE_TIME%:90
%SIP_SIP_PORT%:5060
%SIP_RTP_PORT%:5004
%SIP_RTP_PORT_RANGE%:20
%SIP_RTP_PRIORITY%:0
%SIP_SIP_PRIORITY%:0
PIN Protection of Handset Menus
This setting is used for adding pin code protection of the following handset menus:
• VoIP settings
• Network settings menu
• System settings menu
• Telephony Settings | VoIP line
• Telephony Settings |Call groups.
Pin protection can be enabled and disabled individually using the configuration parameter
PINCODE_PROTECTED_SETTINGS which is a bit mask field.
Pin code protection is enabled by writing 1 and is disabled by writing 0 in the corresponding bit
field. The values in three most significant bits are reserved for future use. Currently the values
are ignored. The default value is 0x00 disabling pin code protection on all the settings.
The popup in idle mode announcing new firmware will not be displayed when the system
settings menu is pin code protected and the popup shown when NAT provisioning fails will not
be displayed when the internet settings menu is pin code protected.
Bit Setting
0 (LSB) VoipSettings
1 VoipLine
2 CallGroups
3 SystemSettings
4 NetworkSettings
5 Reserved
6 Reserved
7 (MSB) Reserved