Filter
Top Products
Configure all Handsets Using the Configurator Web Interface
Mitel
®
5000 CP IP DECT Stand Configuration and Administration Guide – Issue 1.0, May 2010 Page 9
Configure all Handsets Using the Configurator Web Interface
You access the IP DECT Stand Configurator web interface by entering the IP address of the IP
DECT Stand into the address field on a web browser (such as Internet Explorer) on a PC
connected to the local network. The following procedure covers the minimum configuration
required to set up the handsets:
1. Press the Volume Up key on the side of the 5610 Cordless Handset to enter the system
status display. The display shows the MAC address of the handset and the IP address of
the IP DECT Stand. Note that the Boot Status of the handset is displayed as “Failed”.
Ignore the displayed boot status because it is not accurate.
2. Record the IP address that is shown in the display: ____________________________.
This IP address is the address of the IP DECT Stand.
3. Obtain and record the Handset IDs (IPEIs). On each handset:
• Press OK to access the main menu.
• Select Settings.
• Press OK.
• Select Handset ID.
• Press OK. The handset IPEI is displayed.
• Record the IPEI:
Handset 1 IPEI: _______________________________
Handset 2 IPEI: _______________________________
Handset 3 IPEI: _______________________________
Handset 4 IPEI: _______________________________
Handset 5 IPEI: _______________________________
Handset 6 IPEI: _______________________________
Handset 7 IPEI: _______________________________
Handset 8 IPEI: _______________________________
• Press Back to exit.
4. Launch a web browser on a PC that is connected to the local network.
5. Enter the IP address (for example http://10.10.106.235) of the IP DECT Stand
(from Step 2) in the browser address field.
6. At the login screen enter the following default user name and password:
User name: admin
Password: admin
A web page similar to the example on the following page appears.
NOTE
You can reset the stand to the default configuration values (including the
user name and password) using the RESET button on the IP DECT Stand.
Press and hold the RESET button for greater than 10 seconds to reset the
stand configuration to the default values.