Filter
Top Products
Setup\Pincode Settings
Mitel
®
5000 CP IP DECT Stand Configuration and Administration Guide – Issue 1.0, May 2010 Page 17
Setup\Pincode Settings
You can set the PINs for accessing the IP DECT Stand (via the handset) and the external TFTP
account settings.
Setup\Telephony Settings
You can map handsets to account configurations (display names, PINs, and so forth). It also
provides a mechanism to enforce/restrict handsets to register with a specific stand.
Destination for Incoming call
Check the box of the handset account where you want incoming calls to ring.
Outgoing Identity to be used for
Handset Name
Enter the display name for this handset.
IPEI for Handset
Enter the IPEI information for each handset. Set the option “Match IPEI to handset” to “Enable”
in environments where stand signals may overlap, such as hospitality. These settings prevent
handsets from registering to the wrong base stand.
DND (Do Not Disturb)
Disable this option. Although the 5000 CP does not currently provide DND capability to SIP
phones, Mitel recommends not using the local 5610 DND feature.
CW (Call Waiting)
If a user wants to be notified of an incoming call while active on an existing call, enable this
feature. (The Maximum Number of Calls field in 5000 CP SIP phone programming must also be
set to two.) When enabled, a second call placed to the handset will cause a tone to be played to
the handset earpiece, and the user can look at the display and see who is calling. The user can
then decide whether to accept or reject the call. If the user rejects the call, the caller hears a
busy signal. If this option is disabled, callers hear a busy signal if the user is busy on a call.
Join Calls allowed
Enable this option. This option controls the presentation of the Conference option during certain
call scenarios.
Match IPEI to Handset
Enable this option. Mitel recommends that the IPEI of each handset be registered to prevent
handset/ stand interference. This is only required in scenarios where deployments can overlap
stand signals.
Table 3. PIN Settings
Setting Description
VoIP Settings Pincode Enter the PIN code that the user enters on the handset to
access system menus (for example, System settings).
AC Code Not applicable.
HTTP Server Username Enter the user name for the IP DECT Stand Configurator
web interface (default is admin).
HTTP Server Password Enter the password for the IP DECT Stand Configurator
web interface (default is admin).