Filter
Top Products
IP DECT Stand Configuration Notes
Page 16 Mitel
®
5000 CP IP DECT Stand Configuration and Administration Guide – Issue 1.0, May 2010
IP DECT Stand Configuration Notes
This section contains configuration notes for the IP DECT Stand Configurator web interface
pages and setting.
Operation\Home
This web page provides IP DECT Stand information, including firmware version, MAC address,
IP address, and the registration status of the handsets with the 5000 CP.
Setup\VoIP Account
You can configure up to eight 5610 handsets by using the VoIP Account numbers one through
eight. Program only the actual number of physical handsets that will be deployed because even
when the physical handset device is not present, the IP DECT Stand firmware still registers it
with the SIP service provider. This results in increased network traffic. In addition, if the IP
DECT Stand and 5000 CP programming do not align, SIP registration errors can occur. These
errors are reported to the handsets and the users must clear the errors. Given the periodic
nature of SIP handset registrations, these errors will continue to appear until the IP DECT Stand
and 5000 CP programming are aligned.
Setup\Management Settings
You can use the Management Settings options to define the firmware upgrade policies.
Firmware is provided via Mitel Online. You must provide the TFTP server information to support
firmware upgrades. You can configure the IP DECT Stand to periodically check for upgrades.
Setup\NAT/RTP Settings
The defaults are recommended:
• STUN settings are not required unless the stand and 5000 CP are separated by a SIP-
aware firewall.
• Use the default RTP settings.
• Leave Signaling of Silence Suppression disabled.
Setup\IP Settings
You can use DHCP to provide a dynamic IP address to the handsets. Standard Mitel DHCP
options (43/60 or 124/125) are not supported.
Setup\Time Settings
The IP DECT Stand does not support the use of the DATE header in the SIP REGISTER
message to provide the time and date information. The system requires the use of an NTP
server. Use the NTP server date and time zone settings in the 5000 DB Programming to set the
IP DECT Stand date and time zone.