Filter
Top Products
About the Handset Connection Status Indicators
Page 4 Mitel
®
5000 CP IP DECT Stand Configuration and Administration Guide – Issue 1.0, May 2010
To determine if a handset call is being supported by the repeater by using the verification tone:
1. Enable the verification tone feature on the stand. (Refer to the RTX4002 DECT Repeater
User Manual for instructions.) By default, this tone is disabled.
2. Initiate a call from the handset in the repeater area when this tone is enabled. If the call
is being supported by the repeater, you hear the verification tone (a single tone repeated
every 2.5 seconds).
3. Disable the verification tone.
About the Handset Connection Status Indicators
The two semi circles in the top left corner of the handset main display indicate the connection
status of the handset. The left semi-circle indicates the status of the handset registration to the
stand, and the right semi-circle indicates the status of the SIP connectivity to the 5000 CP, as
described below (and shown in the following figure):
• Black/Black: Handset is not registered with the IP DECT Stand or the handset is out of
range. If moving the handset closer to the stand does not change the semi circles to
White/White, re-register the handset with the stand.
• White/Black: Handset is within range of the stand but is not configured to receive calls.
• White/White: Handset is registered with the stand and configured correctly to receive
calls.
Figure 1. Handset Display Status Indicators