Filter
Top Products
Mitel 5604 Wireless Handset User Guide
100
LED Indications during Easy Replacement
The following table shows the LED indications that are used for the 5604 and the charger during
the easy replacement procedure.
See also “Troubleshooting” on page 93.
4, 5 When the text "Please insert old phone in charger" appears, replace the new handset with the
old handset.
The handset can either be switched on or off.
Note: If the rack charger is used, the same charging slot has to be used for both handsets.
The handset will be restarted and after a few seconds. The text "Saving settings. Do not remove
phone from charger" appears.
The charger LED changes to slow orange flashing.
IMPORTANT: Do not remove the handset while the text "Saving settings. Do not remove phone
from charger" appears. It may take several minutes.
6, 7 When the text "Please insert new phone in charger" appears, replace the old handset with the
new handset.
The text "Restoring settings" appears.
IMPORTANT: Do not remove the handset while the text "Restoring settings" appears
8 When the text "Phone successfully replaced. Please remove phone to restart." appears, remove
the handset from the charger. The handset is automatically restarted.
LED indication
Description
Orange, flashing (1 000 ms on, 1 000 ms off) File transfer during Easy Replacement
Orange, flashing (100 ms on, 800 ms off) “Change phone” indication during Easy Replacement
Red, flashing (100 ms on, 800 ms off) Error indication during Easy Replacement. Put back old
handset in charger
Red, flashing (900 ms on, 100 ms off) Error during Easy Replacement. Service needed for
both handsets