Filter
Top Products
Maintenance
99
Easy Replacement Procedure
During the Easy Replacement procedure, the LEDs of the handset and the charger follow the
same LED indications. This means that if the old handset has a broken display, the LED
indications on the charger and on the handset can be used to follow the replacement procedure.
Before and after easy replacement, the LEDs may have different LED indications. For more
details, see “LED Indications during Easy Replacement” on page 100.
IMPORTANT: Never remove a handset from the charger until the instructions in the
display or the LED tells you to do so. (See the status on the LED if the display is broken).
If an error is indicated you may be able to remove the handset. See the Mitel 5604 Wireless
Handset Configuration Guide for further instructions.
After you place the old handset in the charger, you must place the new handset in the
charger, regardless of whether the replacement was successful or not. Failing to do so
may result in malfunction and the new handset will need servicing.
Figure 17: Easy Replacement using the 5604 Programmer
1 On the new handset, press and hold
Note: Do not release until you are instructed to do so.
2 Put the new handset in the charger.
3 When the text "Start phone replacement?" appears, release .
Press "Yes" (left soft key).
The text "Follow the instructions. Each step can take several minutes." appears.
Press "OK"(left soft key).