Filter
Top Products
Meridian Digital Telephone IP Adapter Installation and Administration Guide 69
October 2001 Configuring the IP Adapter unit using the telephone menu
manually enter
static IP
information for
this Meridian
Digital Telephone
IP Adapter
unit,
(continued)
g. Press 2 and proceed to
Enable DiffServ? [1-Yes
2-No]
, below, to leave the Meridian Digital
Telephone IP Adapter
unit’s IP gateway as it is.Press
1 to modify the Meridian Digital Telephone IP
Adapter
unit’s IP gateway.
h. Press the Hold key.
Result: The telephone display prompts you for the
Meridian Digital Telephone IP Adapter unit’s new,
permanent IP gateway. The telephone display also
shows the current setting, similar to the following:
Enter IP Gateway
0.0.0.0
i. Press the digits of the Meridian Digital Telephone IP
Adapter
unit’s permanent IP gateway. Use the * key
for the IP address delimiter. (Refer to the table on
page 55.)
j. Press the Hold key.
Result: The telephone display asks if you want to
enable DiffServ, similar to the following:
Enable DiffServ?
[1-Yes 2-No]
enable prioritizing
of voice packets in
the IP header
(DiffServ),
a. Press 1.
b. Press the Hold key.
c. Proceed to Enable 802.1p Mapping? [1-Yes 2-No]
on page 70.
Note: Refer to the Reach Line Card Installation and
Administration Guide for information on DiffServ
Codepoint and 802.1p mapping.
IF you want to THEN do the following: