Filter
Top Products
Meridian Digital Telephone IP Adapter Installation and Administration Guide 117
October 2001 Administration
Note: Do not ignore error messages in Save to Flash process. If Save to
Flash fails, retry uploading and saving to Flash. If the problem persists,
check the file being uploaded and report the problem to Nortel Networks.
9 From the Upload Configuration dialog box, click on the Save to Flash
button.
Result: The FLASH CONFIG dialog box displays, similar to the following:
10 Click on the Yes button.
Result: The following message displays in the status bar at the bottom of
the screen:
Saving to Flash in Progress
When the save is finished, the following message displays in the middle of
the Upload Configuration dialog box:
CONFIGURATION IS UPDATED INTO FLASH...
11 Click on the Close button.
12 Restart the RLC.
Note: For instructions, refer to “Restarting the system” on page 147.
IF the upload was THEN
successful,
the following message displays:
CONFIG UPLOAD SUCCESSFUL... USE
SAVECFG TO UPDATE FLASH.
not successful,
the following message displays in the middle of
the Upload Configuration dialog box:
CONFIG UPLOAD FAILED
For further instructions, refer to Chapter 8,
“Troubleshooting”.