Filter
Top Products
Effective December, 1998
IL 33-K2C-1
Digitrip Retrofit System for the ITE K-Line Breakers:
K-1600 (Black or Red), KDON-1600 (Black or Red), and K-2000 (Red)
SAFETY PRECAUTIONS
POWER CIRCUIT BREAKERS ARE EQUIPPED
WITH HIGH SPEED, HIGH ENERGY OPERAT-ING
MECHANISMS. THE BREAKERS AND THEIR
ENCLOSURES ARE DESIGNED WITH SEVERAL
BUILT-IN INTERLOCKS AND SAFETY
FEATURES INTENDED TO PROVIDE SAFE AND
PROPER OPERATING SEQUENCES. TO PRO-
VIDE MAXIMUM PROTECTION FOR PERSON-
NEL ASSOCIATED WITH THE INSTALLATION,
OPERATION, AND MAINTENANCE OF THESE
BREAKERS, THE FOLLOWING PRACTICES
MUST BE FOLLOWED. FAILURE TO FOLLOW
THESE PRACTICES MAY RESULT IN DEATH,
PERSONAL INJURY, OR PROPERTY DAMAGE.
•Only qualified persons, as defined in the National
Electric Code, who are familiar with the installa-
tion and maintenance of power circuit breakers
and their associated switchgear assemblies
should perform any work associated with
these breakers.
•Completely read and understand all instructions
before attempting any installation, operation,
maintenance, or modification of these breakers.
•Always turn off and lock out the power
source feeding the breaker prior to attempt-
ing any installation, maintenance, or modifi-
cation of the breaker. Do not use the circuit
breaker as the sole means for isolating a
high voltage circuit. Follow all lockout and
tagging rules of the National Electric Code
and all other applicable codes, regulations,
and work rules.
•Do not work on a closed breaker or a breaker with
the closing springs charged. Trip (open) the
breaker and be sure the stored energy springs
are discharged before performing any work. The
breaker may trip open or the charging springs
may discharge, causing crushing or cutting
injuries.
•For drawout breakers, trip (open), and then
remove the breaker to a well-lit work area before
beginning work.
•Do not perform any maintenance: including
breaker charging, closing, tripping, or any other
function which could cause significant movement
of the breaker while it is on the extension rails.
Doing so may cause the breaker to slip from the
rails and fall, potentially causing severe personal
injury to those in the vicinity.
•Do not leave the breaker in an intermediate
position in the switchgear cell. Always leave it
in the connected, disconnected, or
(optional) test position. Failure to do so
could lead to improper positioning of the
breaker and flashover, causing death, serious
personal injury, and / or property damage.
•Do not defeat any safety interlock. Such
interlocks are intended to protect personnel
and equipment from damage due to flashover
and exposed contacts. Defeating an interlock
could lead to death, severe personal injury,
and / or property damage.
!
WARNING