Filter
Top Products
Effective December, 1998
IL 33-K2C-1
Page 15
D. Remove the nuts and lock washers securing the
selected top Breaker Stabs to the Back Plate.
E. Connect each PT Wire to its corresponding
Breaker Stab using the original lock washers
and nuts.
Attention: Before proceeding, it is necessary
to verify which Step 11 is to be followed for
correct installation of the Sensors. This is done
by referring to the Icon(s) with each step.
Step 11: Installing the Sensors
A. Remove the “E” clips and pins securing the
Finger Clusters to the top Breaker Stabs.
Remove the Finger Clusters.
B. Secure the Sensors to the Mounting Angle
using the (6) .250-20 × .500" bolts, (6) lock
washers, and (6) flat washers supplied.
C. Slide the Sensor Assemblies over the top
Breaker Stabs. Do not secure the Sensor
Mounting Angle to the Breaker at this time.
D. Reinstall the top Finger Clusters using the
original hardware.