Vertical Communications DSU and DSU II Telephone User Manual


 
10.5 Storing The Special Purpose
Feature Buttons
In addition to the feature buttons discussed on the previous page, there
are six special purpose buttons that you can arrange as needed. These
buttons provide the following features:
Assist Button—sends a message to an LCD speakerphone that lets
user know, with a tone and a station message display, that you need
assistance.
Automatic Redial Button—causes the system to automatically dial
(every minute for 10 minutes) the last number that you dialed and ring
the number for approximately 30 seconds.
Group Listen Button—allows others to hear a conversation over the
telephone speaker while you use the handset or headset; the distant
party can hear only the conversation transmitted through the handset or
headset.
Response Message Button—makes a non-verbal response to a
SOHVA call. The response appears in the display of the calling
telephone.
Transfer/Conference Autodial Button—enables you to pre-select
telephones to which calls are frequently transferred, allowing a
single-key transfer of calls. This is most commonly used to transfer to a
voice mail system.
Subdued Off-Hook Voice Announce (SOHVA) Button—allows you
to deliver a SOHVA call. With this button you can decide, after hearing
a busy signal, whether the called party should be interrupted in a
SOHVA manner. If so, you can press the button and initiate a SOHVA
call.
When you complete the programming of each feature, you can press
TRANSFER/CONFERENCE and then press another programmable
button location and dial the next feature button storage code to program
another feature. After you have finished programming all of the
features, press SPEAKER to end.
Programming Your Telephone GCA70–245
10–8 LCD Speakerphone Reference Manual