Filter
Top Products
test vrm busyout
Voice over IP for the Cisco AS5800 55
test vrm busyout
To busyout a specific DSP or channels on a specific DSP, use the test vrm busyout privileged EXEC
command.
test vrm busyout slot-number {first-dsp-number {last-dsp-number | {channel number}} | all
Syntax Description
Defaults
No default behavior or values.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
Use the test vrm busyout command to busy out either one specific DSP or a range of DSPs on a
specific VFC. In addition, you can use this comand to busyout a particular channel on a specified
DSP or range of DSPs. To restore the activity of the busied-out DSP(s), use the test vrm unbusyout
command.
Examples
The following example busies out all of the DSPs and associated channels for the VFC located in
slot 4:
router# test vrm busyout 4 all
slot-number Number identifing the slot where the VFC is installed. Values for this
field are 0 to 11.
first-dsp-number Specifies the first DSP in a range to be busied out. Each VFC holds 96
DSPs, so the value for this argument is 1 to 96.
last-dsp-number Specifies the last DSP in a range to be busied out. Each VFC holds 96
DSPs, so the value for this argument is 1 to 96.
channel (Optional) Specifies that a certain channel on the specified DSPs will be
busied out.
number Indicates the channel to be busied out. Values are 1 or 2.
all Indicates that all 96 DSPs on the VFC installed in the defined slot will be
busied out.
Release Modification
12.0(7)T This command was introduced.