Filter
Top Products
Configuration Example
20
Cisco IOS Release 12.0(7)T
Configuring the Cisco 3640 as a Gatekeeper
! Configure the Ethernet interface to be used at the gatekeeper interface.
interface Ethernet0/1
ip address 172.30.00.00 255.255.255.0
no ip directed-broadcast
no logging event link-status
no keepalive
!
! Configure the gatekeeper interface and enable the interface.
gatekeeper
zone local gk3.gg-dn1 gg-dn1 173.50.00.00
zone prefix gk3.gg-dn1 21*
gw-type-prefix 9#* gw ipaddr 173.60.0.0 1720
gw-type-prefix 6#* gw ipaddr 173.60.0.199 1720
no use-proxy gk3.gg-dn1 default inbound-to terminal
no shutdown
!
Configuring the Cisco 2600 as a Gateway
! Configure POTS and VoIP dial peers.
dial-peer voice 88 voip
destination-pattern 11111
tech-prefix 9#
session ras
!
dial-peer voice 11 pots
incoming called-number 11111
destination-pattern 6#12345
port 1/1/1
prefix 12345
!
! Configure the gateway interface.
interface Ethernet0/0
ip address 173.60.0.199 255.255.255.0
no ip directed-broadcast
no ip mroute-cache
no logging event link-status
no keepalive
no cdp enabled
h323-gateway voip interface
h323-gateway voip id gk3.gg-dn1 ipaddr 173.30.0.0 1719
h323-gateway voip h323-id gw6@gg-dn1
h323-gateway voip tech-prefix 6#
!
Configuring the Cisco AS5800 as a Gateway
! Configure the T1 controller. (This configuration is for a T3 card.)
controller T1 1/0/0:1
framing esf
linecode b8zs
pri-group timeslots 1-24
!
! Configure POTS and VoIP dial peers.
dial-peer voice 11111 pots
incoming called-number 12345
destination-pattern 9#11111
direct-inward-dial
port 1/0/0:1:D
prefix 11111