Filter
Top Products
show voice port
Voice over IP for the Cisco AS5800 43
Related Commands
Operations State Operation state of the port.
Operation Type Operation of the E&M signal: two-wire or four-wire.
Noise Regeneration Whether or not background noise should be played to fill silent gaps if VAD is
activated.
Non-Linear Processing Whether or not non-linear processing is enabled for this port.
Music-On-Hold Threshold Configured music-on-hold threshold value for this interface.
In Gain Amount of gain inserted at the receiver side of the interface.
Out Attenuation Amount of attenuation inserted at the transmit side of the interface.
Pulse Rate Timing Pulse dialing rate in pulses per second (pps).
Echo Cancellation Whether or not echo cancellation is enabled for this port.
Echo Cancel Coverage Echo Cancel Coverage for this port.
Connection Mode Connection mode of the interface.
Connection Number Full E.164 telephone number used to establish a connection with the trunk or
PLAR mode.
Initial Time Out Amount of time the system waits for an initial input digit from the caller.
Interdigit Time Out Amount of time the system waits for a subsequent input digit from the caller.
Regional Tone Configured regional tone for this interface.
Command Description
show call active voice Displays the Voice over IP active call table.
show call history voice Displays the Voice over IP call history table.
show dial-peer voice Displays configuration information for dial peers.
show voice port Displays configuration information about a specific voice port.
Table 3 show voice port Field Descriptions for the Cisco AS5800 (continued)
Field Description