Filter
Top Products
show csm
Voice over IP for the Cisco AS5800 33
csm_state CSM call state of the current call (PRI line) associated with this device. Possible
values are:
— CSM_IDLE_STATE—Device is idle.
— CSM_IC_STATE—A device has been assigned to an incoming call.
— CSM_IC1_COLLECT_ADDR_INFO—A device has been selected to
perform ANI/DNIS address collection for this call. ANI/DNIS address
information collection is in progress. The ANI/DNIS is used to decide
whether the call should be processed by a modem or a voice DSP.
— CSM_IC2_RINGING—The device assigned to this incoming call has
been told to get ready for the call.
— CSM_IC3_WAIT_FOR_SWITCH_OVER—A new device is selected to
take over this incoming call from the device collecting the ANI/DNIS
address information.
— CSM_IC4_WAIT_FOR_CARRIER—This call is waiting for the
CONNECT message from the carrier.
— CSM_IC5_CONNECTED—This incoming call is connected to the
central office.
— CSM_IC6_DISCONNECTING—This incoming call is waiting for a
DISCONNECT message from the VTSP module to complete the
disconnect process.
— CSM_OC_STATE —An outgoing call is initiated.
— CSM_OC1_REQUEST_DIGIT—The device is requesting the first digit
for the dial-out number.
— CSM_OC2_COLLECT_1ST_DIGIT—The first digit for the dial-out
number has been collected.
— CSM_OC3_COLLECT_ALL_DIGIT—All the digits for the dial-out
number have been collected.
— CSM_OC4_DIALING—This call is waiting for a dsx0 (B channel) to be
available for dialing out.
— CSM_OC5_WAIT_FOR_CARRIER—This (outgoing) call is waiting for
the central office to connect.
— CSM_OC6_CONNECTED—This (outgoing) call is connected.
— CSM_OC7_BUSY_ERROR—A busy tone has been sent to the device
(for VoIP call, no busy tone is sent; just a DISCONNECT INDICATION
message is sent to the VTSP module) and this call is waiting for a
DISCONNECT message from the VTSP module (or ONHOOK message
from the modem) to complete the disconnect process.
— CSM_OC8_DISCONNECTING—The central office has disconnected
this (outgoing) call and the call is waiting for a DISCONNECT message
from the VTSP module to complete the disconnect process.
csm_state: invalid_event_count= Number of invalid events received by the CSM state machine.
wdt_timeout_count= Number of times the watchdog timer is activated for this call.
wdt_timestamp_started Indicates whether the watchdog timer is activated for this call.
wait_for_dialing: Indicates whether this (outgoing) call is waiting for a free digit collector to
become available to dial out the outgoing digits.
Table 1 show csm voice Field Descriptions (continued)
Field Description