Filter
Top Products
Command Reference
28
Cisco IOS Release 12.0(7)T
Command Mode
Dial-peer configuration
Command History
Usage Guidelines
This command is used for calls incoming from a telephony interface to select an incoming dial peer
and for calls coming from the VoIP network to match a port with the selected outgoing dial peer.
This command applies only to POTS peers.
Example
The following example associates a Cisco 3600 series router POTS dial peer 10 with voice port 1,
which is located on subunit 0, and accessed through port 0:
dial-peer voice 10 pots
port 1/0/0
The following example associates a Cisco MC3810 POTS dial peer 10 with voice port 0, which is
located in slot 1:
dial-peer voice 10 pots
port 1/0
The following example associates a Cisco AS5300 POTS dial peer 10 with voice port 0:D:
dial-peer voice 10 pots
port 0:D
The following example associates a Cisco AS5800 POTS dial peer 10 with voice port 1/0/0:D
(T1 card):
dial-peer voice 10 pots
port 1/0/0:D
The following example associates a Cisco AS5800 POTS dial peer 10 with voice port 1/0/0:1:D
(T3 card):
dial-peer voice 10 pots
port 1/0/0:1:D
Release Modification
11.3(1)T This command was introduced (Cisco 3600 series router).
11.3(3)T Port-specific values for the Cisco 2600 were added.
11.3 MA Port-specific values for the Cisco MC3810 were added.
12.0(3)T Port-specific values for the Cisco AS5300 were added.
12.0(7)T Port-specific values for the Cisco AS5800 were added.