Filter
Top Products
show vrm vdevices
Voice over IP for the Cisco AS5800 47
show vrm vdevices
To display detailed information for a specific DSP or a brief summary display for all VFCs, use the
show vrm vdevices privileged EXEC command.
show vrm vdevices {{vfc-slot-number | voice-device-number} | summary}
Syntax Description
Defaults
No default behavior or values.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
Use the show vrm vdevice to display detailed information for a specific DSP or a brief summary
display for all VFCs. The display provides information on the number of channels, channels per
DSP, bitmap of DSPMs, version numbers, and so on. This information is useful in monitoring the
current state of your VFCs.
The display for a specific DSP provides information on the codec that each channel is using, if active,
or last used and if the channel is not currently transmitting cells. It also displays the state of the
resource. In most cases, if there is an active call on that channel, the resource should be marked
active. If the resource is marked as reset and/or bad, this may be an indication of a response loss for
the VFC on a reset request. If this condition persists, you might experience a problem with the
communication link between the router shelf and the VFC.
vfc-slot-number Slot number of the VFC. Valid number is 0 to 11.
voice-device-number DSP number. Valid number is 1 to 96.
summary List synopsis of voice feature card DSP mappings, capabilities, and
resource states.
Release Modification
12.0(7)T This command was introduced.