Filter
Top Products
Configuration Example
Voice over IP for the Cisco AS5800 19
For more information about configuring IVR, refer to the Cisco IOS Release 12.0(7)T Configuring
Interactive Voice Response for Cisco Access Platforms feature module.
Verifying IVR Configuration
• If you have relatively few dial peers configured, you can use the show dial-peer voice command
to verify that the data configured is correct. Use this command to display a specific dial peer or
to display all configured dial peers.
• Use the show running configuration command to show all configured parameters relating to
IVR.
Configuration Example
The following configuration example shows an abbreviated configuration using a Cisco 2600 router
and a CiscoAS5800 universal access server as gateways and a Cisco 3600 router as a gatekeeper.
Figure 6 shows the network diagram for this particular scenario.
Figure 6 AS5800 Universal Access Server Acting as a Gateway
4
Router(config-dial-peer)# destination-pattern string
Defines the telephone number associated with this POTS
dial peer.
5
Router(config-dial-peer)# port shelf/slot/port:D
Associates this POTS dial peer with a specific logical dial
interface.
6
Router(config-dial-peer)# prefix string
(Optional) Specifies the prefix for this POTS dial peer.
The prefix string value is sent to the telephony interface
first, before the telephone number (destination pattern)
associated with this dial peer is sent.
Step Command Purpose
5000
10BASE-T
10BASE-T
Cisco 2600
Cisco 2600
10BASE-T
NT Server
Cisco CallManage
r
100BASE-T
30460
10BASE-T
Catalyst
5000
Cisco 3640
gatekeeper
AS5800 VoIP
H.323 gateway