Filter
Top Products
Edit System Prompts
This allows you to create or edit system prompts.
! Call the SVMi-8, and access the System Administration Menu.
! Press 1 to edit system prompts.
! Follow the spoken instructions to edit system prompts.
At the very least you will probably need to create the following:
! Day Greeting = Prompt 1001
! Night Greeting = Prompt 1002
! Holiday Greeting = Prompt 1003
! Emergency (Bad Weather) Greeting = Prompt 1004
Only prompts above prompt # 1000 may be recorded using the DTMF System Administration. To record prompts
lower than # 1000 (system prompts) you must use the Voice Studio Administration Tool.
NOTE: When a prompt has been recorded, sometimes there is some ambient noise at the front or back that needs to
be trimmed. Press 4 and select trim mode. You may now clip small amounts of 'noise' from the front or back of the
voice prompt. Repeatedly press 1 (or 2) to trim small amounts from the front (or back) until the prompt sounds
clean.
Subscriber Administration
This allows you to add and delete subscribers.
! Call the SVMi-8, and access the System Administration Menu.
! Press 2 for subscriber information.
! Follow the spoken instructions to create or delete subscribers.
Manual Mode Selection
This allows you to change the operating mode of the SVMi-8. You may select a specific mode (as long as it has been
defined as a mode block) or you may select automatic scheduling. Changes to a specific mode will remain in effect
until you manually change it back to automatic scheduling.
You may select a mode for each port in the system.
! Call the SVMi-8, and access the System Administration Menu.
! Press 3 to manually set the mode.
! Follow the spoken instructions to change the port number
! Follow the spoken instructions to change the operating mode. According to the following list of options:
1 Day Mode
2 Night Mode
Programming Methods
8