Filter
Top Products
Using the Screen Interface
After connecting the terminal equipment press ‘Ctrl+L' to clear and refresh the screen. You will see a status of the
current operating condition including the status of each port and some general system data.
The main screen looks like this and shows port activity and general statistics.
Logging In
To log into the system press the ESCAPE key and enter the password, the default password is 0000. You will now be
at the System Administration Main Menu, and are ready to begin programming.
NOTE: From time to time 'electronic noise' on the serial cable may cause some erroneous characters to print on the
terminal, or some items not to be displayed correctly. If this happens you should press 'Ctrl + L'. This will refresh the
screen.
Getting Help
The key-strokes available to you during editing can be viewed by pressing F1, and are as follows:
F1 Navigation Keys Help
Ctrl + E Save and RETURN TO Starting Facility
Ctrl + A Save Block As
Ctrl + O Save and OPEN Block or Prompt Text under Cursor
Ctrl + R Save and RETURN TO LAST Block in Control Path
Ctrl + N Save and OPEN Next Block of Same Type or Template Blocks
Ctrl + V Save and OPEN Previous Block of Same Type or Templates
Ctrl + F Find Blocks that refer to the Current Block
F3 Sort in Current Object or Facility
Programming Methods
6