Filter
Top Products
26 Tone Commander 7210/7220 User Manual
If DHCP is currently enabled, select DISABLE.
Press the Done key to return to the IP Configuration Update
menu or the Setup key to exit Setup Mode.
Manual IP Configuration
DHCP should be disabled if manual IP configuration is used; IP
addresses configured via DHCP will overwrite manually entered values.
From the Installation Options menu, select IP.
(Setup → INSTL → IP)
Select PHONE, TFTP, GATEWY, iMERGE, SNTP, or
SUBNET.
Using the dial pad, enter the IP addresses. Address format is
four groups of 1-3 digits. You must enter leading zeroes for
each group of digits. Periods are automatically displayed.
If you need to make corrections, select
!
BKSP (backspace)
to delete the previous digit.
CLEAR removes all digits, allowing you to start over.
The subnet mask is entered in a similar manner; the default
value of 255.255.255.0 will suffice in most cases.
For SNTP, select OFFSET to specify the time offset (in hours)
from UTC for your local time zone.
PHONE=192.169.073.104
|BKSP CLEAR PING
DHCP=DISABLED
ENABLE DISABLE
Done
IP ADDRESSES \
PHONE GATEWY TFTP iMERGE
IP ADDRESSES \
SNTP SUBNET