Filter
Top Products
18 Tone Commander 7210/7220 User Manual
Power
Power must be provided by the Tone Commander 901034 power
supply. Connect power after all other connections are complete. The
7210 and 7220 are not compatible with IEEE LAN-based power.
Plug the power supply barrel connector into the round jack on the
bottom of the phone (under the speaker). Connect the power supply to
a standard 120 VAC, 60 Hz grounded power outlet.
Wall Mounting
___________________________
Robust handset retainer clips for wall mount use are available on
request from Tone Commander.
Rotating the Base
The phone base must be rotated for wall mounting.
• Disconnect power, PC, and network cables.
• Remove the retaining screw in the center of the base.
• Press the top of the tall edge of the base to disengage the snap
tabs, then lift the base from the telephone body.
Make sure the cable from the base remains fully seated in the
connector on the phone.
• Turn the base 180°, insert the tabs on the short edge of the base
into the holes near the display end of the telephone, and then snap
the tall side of the base onto the telephone.
• Replace the retaining screw (required for UL compliance).
Attaching to a wall mount jack
• Plug an 8”, 10/100BaseT network cable into the NET jack on the
telephone. Route the cord under the guide tabs on the base.
• Hold the telephone next to the wall mount jack. Plug the network
cable into the jack.
• Hang the telephone on the wall plate mounting studs. Press down
firmly to lock in place.
• Push any excess network cable into the base.