Nortel Networks 7210 Telephone User Manual


 
Tone Commander 7210/7220 User Manual 17
Installation
Ordering ISDN Service
____________________
ISDN ordering forms may be supplied by your service provider. You
can also print forms using the PC-based Configuration Wizard. Please
refer to Appendix A in this manual.
Consult your service provider to plan your service installation. Allow
adequate time after cutover for testing of all call appearances and
programmed features. Ask your service provider for your alias and
H.235 password, and confirm the installation date.
7210/7220 Installation
_____________________
Network Connection
Connect the NET jack on the phone to the LAN switch using a
Category 5 or better cable. Route the cable under the guide tabs in the
phone base.
PC Connection
If you want to use a PC on the same network connection, connect the
PC network interface card to the phone's PC jack switch using a
Category 5 or better cable. Route the cable under the guide tabs in the
phone base.
The PC port device's speed must match that of the device connected to
NET port (LAN switch or hub). If the NET port is connected to a
100Mbps device (either dual or single speed), a 10Mbps device
connected to the PC port will not work properly. If the NET port is
connected to a 10Mbps device, a 10Mbps device (or 10/100Mbps dual-
speed device) connected to the PC port will communicate properly at
10Mbps.
Handset/Headset
Plug the supplied handset or a compatible headset into the jack on the
left side of the telephone.