Filter
Top Products
Tone Commander 7210/7220 User Manual 19
Configure the Set
________________________
ISDN configuration is performed automatically in many cases. The
telephone set will detect the switch type, set the SPID number, and
download other setup parameters when these features are available
from the central office.
You will be prompted for any required setup information that cannot be
set automatically.
Initialization
A self-test is performed upon power up, followed by terminal
initialization. Initialization begins after a short random time interval. This
delay prevents multiple terminals at a site from initializing
simultaneously after a power outage.
The display will show progress while establishing the communication
layers. When all communication layers are established, the IP
connection speed and switch type will be shown for several seconds.
IP addresses are normally assigned via DHCP server. In the case
where there is no DHCP server or no server response, the following
display will be shown:
If the IP address, default gateway, or subnet mask have changed, the
following will be shown:
Select YES to restart the phone using the new addresses or subnet
mask.
PHY:100MBPS IP:LINKED
L3:OK SWITCH=5ESS NI-X
DHCP ERROR, RETRYING
PRESS SETUP TO CONFIGURE
RESTART WITH NEW VALUES?
YES