Filter
Top Products
Tone Commander 7210/7220 User Manual 15
Using Voice Announce
____________________
The Voice Announce feature may be used to provide hands-free call
announcing of screened calls or station-level paging when your phone
is on-hook. Incoming calls that meet specific predefined criteria (see
page 39) can be answered automatically by the speakerphone. The
microphone can be automatically disabled for announcing only, or
enabled to allow two-way conversations. You can enable or disable
Voice Announce at any time.
Enabling/Disabling
When the phone is idle, the display will show the current Voice
Announce state.
The Voice Announce state is shown only if Voice Announce
keys have been set up as explained on page 39.
Press the softkey beneath the VA display to enable or disable
Voice Announce.
Receiving Voice Announce Calls
Calls selected for voice announcing will be answered automatically.
You and the caller will hear a double beep if your microphone is muted,
or a single beep if your microphone is enabled. The call will disconnect
when the caller hangs up. After the call has been answered, you can
pick up the handset for a private conversation, turn muting on or off,
press the Spkr key to disconnect, and perform other normal call
operations. Voice Announce is disabled when you are on an active
call with the handset, headset, or speakerphone.
CAUTION – If Call Announce is enabled for a calling directory number,
the caller should not transfer calls unscreened (blind) to your
telephone, otherwise the transferred call will be answered using Voice
Announce.
UNANS VA ON