Filter
Top Products
CHAPTER 5 ND-70895 (E)
Page 60
Revision 1.0
OFFICE DATA DESIGN
Procedure for Setting Basic Office Data for OAI System
2. Procedure for Setting Basic Office Data for OAI System
The procedure for setting the office data for OAI system is explained in the following.
2.1 Data for OAI System
1. ASYD/ASYDL
ASYD-SYS1 INDEX31 - b0 ~ 3 : CM mounting capacity (Normally Assign “04”.)
INDEX79 - b6 = 0 (OAI service is in service)
INDEX207 - b0 (IP in system 0), b1 (IP in system 1)
Assign “1” to the corresponding bit for the IP accommodation.
INDEX241 - b2 = 1 (Call Processing Event Notification)
INDEX241 - b3 = 1 (Details of SCF Error Notification)
ASYDL-SYS1 INDEX513 : 01 Hex (LDM usage)
INDEX515~518 : IP address (Hex) for PBX over External LAN
INDEX519~522 : Subnet Mask (Hex) for PBX over External LAN
INDEX523~526 : Default Gateway Address for External LAN
(This data is required when the Host is connected via gateway)
INDEX864 - b0 = 1 (Built-in IP is provided)
INDEX864 b1 : Output the system message (4-R) when TCP-IP is normally
disconnected.
0/1 = Effective/Ineffective
2. ARNP (Reverse Numbering Plan Data)
If necessary, assign the self office code when assigning office information within a message of
the facility