Filter
Top Products
CHAPTER 4 ND-70895 (E)
Page 42
Revision 1.0
COMMANDS
ASPA
ASPA: Assignment of Specific Access Code
24. Functions
This command is used to assign/delete/display each data which respectively determines what kind of
service should be executed and/or which route should be used, etc. when a special access code, C.O. line
access code or Tie-Line access code has been dialed.
25. Precaution
(a) For the details of special access code data, refer to the description of ASPA command in the Feature
Programming Manual and Office Data Specification for the NEAX2400 IMX. Explanations here will
be limited only to the items pertaining to the OAI System.
(b) For assigning OAI Dial Number Batch Transfer (SRV = SSCA, SIDA = 69), be sure to set the
number of digits (max. 3 digits) of the OAI access code to Necessary Number of Digits (NND).
26. Parameters
SIDA: Service Feature Index A (69)
69: OAI Dial Number Batch Transfer (TMF)
Note:
For the details of other parameters, refer to the description of ASPA command in the Office Data
Specification for the NEAX2400 IMX.
Specific Access Code Data Assign Table
The Office Data Sheets of this ASPA command are attached only to the pages pertaining to the data to be
assigned in the OAI System. Replace these Office Data Sheets with those for ASPA command of the
NEAX2400 IMX.
Table 4-2 Supplementary Service Codes
TENANT
NUMBER
(TN)
ACCESS
CODE
(ACC)
CONNECTION
STATUS INDEX
(CI)
KIND OF
SERVICE
(SRV)
SERVICE FEA-
TURE INDEX A
(SIDA)
REMARKS
1 ~ 31
1 ~ 3
DIGITS
N/H/B SSCA
NNormal
SSCA 69
OAI Dial Number Batch Trans-
fer (TMF)
H Hooking