Filter
Top Products
ND-70895 (E) CHAPTER 4
Page 29
Revision 1.0
COMMANDS
AADT
AADT: Assignment of Announcement/Dictation Trunks
1. Functions
This command is used to assign/delete Announcement Trunks or Dictation Trunks.
2. Precaution
When changing the LENS of the currently assigned Announcement/Dictation Trunks, delete the assigned
data first by this command, and then change the LENS by Assignment of Trunk Data (ATRK) command.
It must be remembered that, if the LENS data are deleted first by ATRK command by mistake, the data
currently assigned by this AADT command are automatically deleted.
3. Parameters
TYPE : Announcement Trunk (ANT), Dictation Trunk (DCT)
NO. : Message Number
D : Disconnect Timer (0/1); Valid when TYPE = ANT
0: Impossible (Repeat)
1: Possible (Disconnect by MSGT)
MSGT : Message Timer (2 ~ 120 sec., 2-sec. interval when shorter than 30 sec., 8-sec. interval
when longer than 30 sec.)
CP : Connection Pattern
Note
0: Multiple Connection
1: Single Connection
WAIT : Waiting Timer (0~30 sec., 2-sec. interval)
Note
Note:
Available only when the system data is programmed that the DAT control function is available (ASYD,
SYS1, INDEX449, b2=1).
CNT : Number of ANT/DCT Trunks assigned or to be assigned (1 ~ 8)
RT : Route Number
TK : Trunk Number
4. Related Commands
List Up : LADT