Filter
Top Products
CHAPTER 6 ND-70895 (E)
Page 90
Revision 1.0
MAINTENANCE
System Messages
3.2 Message Detail Data
This paragraph describes the detailed information on the faults indicated by system messages (message
detail data).
3.2.1 Message Detail Data of System Message “4-R”
System Message 4-R: TCP/IP Link Failure
1. Print-out Format
2. Print-out information (typical)
Fault port number: 0-5
Communication Protocol: 03 = ETHER + TCP/IP
Error Code (ERRK): Refer to the table below (6-3 ERROR CODE)
Fault logical channel number (LCID) : 01~10H (00 means the data is invalid)
~ IP address
Note 1:
This error code shows that the Host (UAP) is down manually. You can program not to output this detail
message at some offices using SYS1, INDEX864, b1 in ASYDL (Other messages than ERRK = 01 is output
when TCP connection disconnected is not output).
Note 2:
This data is output for Series 7300 Release 6 or earlier. If your system is Series 7300 Release 7 or later, the
message is output by 26-V” instead. (Refer to Section 3.2.2)
Relation between LCID and PBX TCP port number
LCID TCP port number of the PBX
01 60030
Table 6-3 Error Code
PROTOCOL ERROR CODE CONTENT OF FAULT
03
(ETHER + TCP/IP)
01 TCP Connection disconnected (Normal) Note 1
02 Reception of a text that cannot be analyzed Note 2
03~09 Not used
10 (0A) TCP Connection disconnected (On the way) Note 2
11 (0B) Transmission to PZ-PC19 (LANI) is disabled (Permanent) Note 2
12 (0C) Abnormal UAP is detected by Heart Beat function
13 (0D) Not used
14 (0E) TCP/IP Connection Error (B-level Infinite Loop, etc.) Note 2
15 (0F) Not used
SYSTEM MESSAGE 4-R TCP/IP Link Failure
NEC - ESD DEC 22 21:32
1: xx xx xx xx xx xx xx xx 2: 00 00 00 00 00 00 00 00
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16
1
2
3
4
5 8
2 3