Filter
Top Products
CHAPTER 3 ND-70895 (E)
Page 22
Revision 1.0
INSTALLATION PROCEDURE
OAI Software Installation
STEP 6: Assign the system data written in LDM.
ASYDL SYS1
INDEX512: FPC of the self-node
When OAI system is used through the Fusion Network, this data setting is necessary at each node in the network
.
INDEX513: 01 Hex (LDM usage)
INDEX515~518 b0~b7: IP address (Hex) for PBX over external LAN
Note 4
INDEX519~522 b0~b7: Subnet Mask (Hex) for PBX over external LAN
Note 4
INDEX523~526 b0~b7: Default Gateway Address for External LAN
Note 4
(This data is required when the Host is connected via gateway)
INDEX864 - b0=1 (Built-in IP is provided)
When OAI system is used in the Fusion Network (OAI Terminal Anywhere) [available since the Series 7400 (Release 8)
software], assign “1” at the node that has the IP.
INDEX864 b1 :Output the system message (4-R) when TCP-IP is normally disconnected.
0/1=Effective/Ineffective
Note 4:
If the MAT or SMDR has been connected with external LAN already, this data assignment is not necessary.
STEP 7: Check the station-to-station connection and confirm no fault status occurs or system messages are
output (such as cable connection fault, LCD display fault, memory alarm fault, abnormal interrupt
etc.).
STEP 8: Program the OAI office data. Also, program the Fusion data to make ACD service effective through
Fusion network, if necessary.
STEP 9: Save the DM into the HDD by using MEM_HDD.