Filter
Top Products
CHAPTER 4 ND-70895 (E)
Page 36
Revision 1.0
COMMANDS
AOAC
AOAC: Assignment of OAI Access Code
16. Functions
This command is used to assign/delete the Facility Kind and the Operation Code on a basis of each service
access code of the OAI System.
17. Precaution
(a) When setting a minus value (less than 0) to the parameter “OP-CODE”, add “-” (minus symbol)
ahead to the value.
If the set value is a positive value, it is automatically interpreted to be a positive value even if “+”
(plus symbol) is not added ahead of the value.
(b) For assigning OAI access codes, it is necessary to assign the necessary number of digits of OAI
access codes by AOKC command in advance to assigning the codes.
18. Parameters
OAI-ACC : OAI Access Codes (000 ~ ###) (Max. 3 digits)
F-KIND : Facility Kind (1 ~ 15)
1: Terminal Mode Set Facility (MSF)
2: Terminal Multiple Information Transfer Facility (TMF)
3:
Not used
15:
OP-CODE : Operation Codes (128~ 255)
When F-KIND = 1, 128 ~ 191
When F-KIND = 2, 192 ~ 255
19. Related Command
List Up : LOAC