Filter
Top Products
CHAPTER 4 ND-70895 (E)
Page 38
Revision 1.0
COMMANDS
AOKC
AOKC: Assignment of OAI Key Code
20. Functions
This command is used to assign/delete the Facility Kind and the Operation Code on a basis of each function
key on the D
term
.
21. Precaution
(a) The OAI code for which F-KIND = 3 (Open Application Interface) can be assigned is only one per
system.
(b) When deleting the Open Application Interface (OAI) key code for which F-KIND = 3 is assigned, it
is necessary, in advance to the intended deletion, to delete all the OAI access code data assigned by
AOAC.
(c) When OAI key data has been assigned/deleted on basis of a function key by this command, operation
of the OAI key is ignored only once immediately after that assignment/deletion or immediately after
a system initialization.
22. Parameters
KEY-CODE: OAI Key Codes (1 ~ 31)
Note 1
F-KIND : Facility Kind (1 ~ 15)
1: Terminal Mode Set Facility (MSF)
2: Terminal Multiple Information Transfer Facility (TMF)
3: Open Application Interface (OAI)
4: Key Code Transfer Facility (KTF)
5.
Not used
15:
C-TONE : Chime control on normal end of MSF, TMF, and OAI
0: To be controlled
1: Not to be controlled (No Tone)
NND : Necessary Number of Digits (1 ~ 3)
Note 2
OP-CODE : Operation Codes
Note 3
(128 ~ 255)
Operation
Codes
128 (0080)H: MSF
OAI
(Terminal Mode Set Facility)
191 (00BF)H: MSF
192 (00C0)H: TMF
OAI
(Terminal Multiple Information Transfer Facility)
255 (00FF)H: TMF