Filter
Top Products
F
IXED
K
EYS S
ELEC
S
ET
500A U
SER
G
UIDE
1-14 HCXTD840, Issue 1, July 2001
Table 1-1 SelecSet 500A Fixed Keys
Key Name Function/operation
<ALARM> The major/minor alarm lights steadily when a system
malfunction is detected. The alarm remains lit until the
problem is corrected.
<NIGHT> Press <NIGHT> to place the system in night mode
(CAP1-CAP4) Call appearances are virtual lines that are used to receive/
place/hold calls while call control operations are performed.
CAPs can represent up to four calls, with each CAP
representing one call.
<HLD1>-<HLD4> Hold loops are used to place up to four calls on hold, with
each held call represented by a display. (Each hold loop can
be used to place a single call on hold).
<DSPL> Press <DSPL> to display functions of programmed keys
<CONF> Press <CONF> to establish a conference call. Press
<JOIN>, dial a station number or outside number and press
<CONF> to establish a three-party conference. Press
<CONF>, dial a number and press <CONF> again to
establish a multiparty conference of up to six parties.
<SWAP> Press <SWAP> to alternate between two sides of a split call.
<START> Press <START> to originate calls or perform other call
processing functions (like picking up the receiver on other
phones). Gives or cancels dial tone.
<CNCL> Press <CNCL> during call transfer if you misdial a number.
Pressing this key disconnects the last party added to a
conference.
<HOLD> Press <HOLD> to place an active call on hold.
<JOIN> Press <JOIN> to transfer a call and return to the idle state.
<ANS> Press <ANS> to answer all calls that ring at the attendant
position.