Filter
Top Products
3-9
Cisco VG224 Voice Gateway Hardware Installation Guide
OL-5006-04
Chapter 3 Installing the Cisco VG224 Voice Gateway
Wall-Mounting the Chassis
Wall-Mounting the Chassis
The following warning applies only when the unit is wall-mounted:
Warning
This unit is intended to be mounted on a wall. Please read the wall-mounting instructions carefully
before beginning installation. Failure to use the correct hardware or to follow the correct procedures
could result in a hazardous situation to people and damage to the system.
Statement 248
Caution
You can wall-mount the unit with either the right or left side facing up; however, the front and rear panels
must be vertical.
Note
For information about obtaining the chassis guard, refer to field notice number 28655, VG224 Chassis
Guard - Safety Regulation, at http://www.cisco.com/en/US/ts/fn/200/fn28655.html.
To wall-mount the chassis, follow this procedure:
Step 1
Attach the short leg of one bracket to the chassis, as shown in Figure 3-6, using two 6-32 x 1/4 slotted
hex screws (provided). Be sure to use a plastic washer (provided) with each screw; the narrow end of the
washer must fit into the bracket slot, facing the chassis.
Caution
Be sure to use the correct screws and plastic washers for this mounting option. (See Table 3-1 on
page 3-6.)
Figure 3-6 Attaching the Brackets for Wall-Mounting
Step 2
Attach the second bracket to the opposite side of the chassis.
Step 3
Attach the router to the wall using the brackets previously attached and attachment hardware that you
provide as follows:
•
You can install a starter screw in the wall, and hook the bracket keyhole over the screw. This holds
the unit in place for easy installation of the attachment screws.
•
Attach both brackets to the wall.
88843