Filter
Top Products
3-8
Cisco VG224 Voice Gateway Hardware Installation Guide
OL-5006-04
Chapter 3 Installing the Cisco VG224 Voice Gateway
Rack-Mounting the Chassis
Installing the Cisco VG224 Voice Gateway in a Rack
The following warning applies only when the unit is rack-mounted:
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component
at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.
Statement 1006
To rack-mount the chassis, follow this procedure:
Step 1
Choose one of the methods shown in Figure 3-3 on page 3-7, or Figure 3-4 on page 3-7, and attach the
long leg of the mounting brackets to the chassis, as shown.
Caution
Make sure to use the correct screws for this mounting option (see Table 3-1 on page 3-6).
Screws are included for attaching the brackets to the chassis, but not for installing the chassis in a rack
or on a wall. You need four additional machine screws to install the chassis in a rack. Use the screw size
required by your rack. After the brackets are secured to the chassis, you can rack-mount the chassis.
Step 2
Using screws that you provide, attach the chassis to the rack as shown in Figure 3-5 on page 3-8.
Figure 3-5 Attaching the Chassis to the 19-Inch Rack
103039
VG224